Re: Balancing between default routes

Hello,

Your link costs do not look equal:

Interface           State   Area            DR ID           BDR ID          Nbrs
vlan.1108           BDR     0.0.0.0         x.x.225.12   10.10.10.12        1
  Type: LAN, Address: x.x.225.37, Mask: 255.255.255.252, MTU: 1500, Cost: 150
  DR addr: x.x.225.38, BDR addr: x.x.225.37, Priority: 128
  Adj count: 1
  Hello: 1, Dead: 3, ReXmit: 5, Not Stub
  Auth type: None
  Protection type: None
  Topology default (ID 0) -> Cost: 140
vlan.1110           DR      0.0.0.0         10.10.10.12     x.x.232.89      1
  Type: LAN, Address: x.x.225.41, Mask: 255.255.255.252, MTU: 1500, Cost: 150
  DR addr: x.x.225.41, BDR addr: x.x.225.42, Priority: 128
  Adj count: 1
  Hello: 1, Dead: 3, ReXmit: 5, Not Stub
  Auth type: None
  Protection type: None
  Topology default (ID 0) -> Cost: 150

Regarding Your config below - are You sure this is from the same EX You are having problems with, and not from other box?

set protocols ospf area 0.0.0.0 interface vlan.1108 metric 150
set protocols ospf area 0.0.0.0 interface vlan.1110 metric 150

HTH

Thx

Alex