vpls multiple vlans with vlan-id-list
Hi, I've read several kb articles about multiple vlans in 1 vpls instance, but I must admit they are not all that clear are do not go deep enough so that I can understand what goes on behind the...
View ArticleRe: Policy option import direct not working
When you show the routes in VRF-LAB are they listed as direct? show route table VRF-LAB.inet.0
View ArticleRe: IPSEC Tunnel over VLANS
ok, so to recap: ge-0/0/0 on A and D will be the gateway for the VPNAre the internal interface addresses on these ports reachable to each other in the current network?10.0.0.0/29 to 10.0.0.16/29 If...
View ArticleMPLS, RSVP-TE - number of LSPs question
Hi All, Are there any best practices on number of LSPs that can be configured between 2 routers. For example I have 2 routers A (in westcoast) and B (east coast) with 4 10Gig links between them. All...
View ArticleRe: MPLS, RSVP-TE - number of LSPs question
Hello,I would say there is not enough information provided.Can You build a 4x10GE LAG?Do You expect elephant flows? If yes what is the elephant flow expected max size?Can You use TE++?HTHThanksAlex
View ArticleClik here to view.
VPLS Multihoming between CEs to the same PE pair
Hi all,I have a setup as seen below, VPLS Multihoming between two seperate CEs which are dual-homed to the same PE-pair. This is one small section of a larger MPLS core, so the PEs highlighted also...
View ArticleRe: MPLS, RSVP-TE - number of LSPs question
Thanks Alex, yes can bundle those 4 links into one but then still how many LSPs would be better to have on that lag? Also how would adding TE affect the number of LSP question
View ArticleJuniper MX maximum MTU
Hello All, hope you are doing well. I was checking the maximum MTU I can configure in a MX960 and it was 9192, but in a EX4200 it's 9216. Why the 24 bytes difference? Most importantly, if a customer...
View ArticleRe: MPLS, RSVP-TE - number of LSPs question
There's no rule or best practice that says if you have four diverse links, you should have a specific number of LSPs. Maybe you don't want to utilize all links at the same time in case of link...
View ArticleRe: MPLS VPNs, Route-Reflection, and SPRING with IS-IS on QFX5100
In that case inet-unicast (AFI 1 SAFI 1) does not need LSPs, so you can peer those using the secondary IP. For anything that needs LSPs, use the primary IP for peering. What's the reason for having...
View Articlesystem id's suffixes on protocol isis
Hi all, I'm so confused about suffixes system id on protocol isis. When I show "show isis database"user@host> show isis databaseIS-IS level 1 link-state database: LSP ID Sequence Checksum Lifetime...
View ArticleRe: system id's suffixes on protocol isis
glacier.02-00 - designated intermediate system (DIS)
View ArticleRe: MPLS, RSVP-TE - number of LSPs question
Hello,sidd wrote:Thanks Alex, yes can bundle those 4 links into one but then still how many LSPs would be better to have on that lag? Assuming You have MX series router with Trio HW that can...
View ArticleRe: system id's suffixes on protocol isis
Hi, For each LAN segment there should be a DIS. Except 00-00 all LSPs in the "show isis database" whether 02-00, 03-00 or 04-00 are generated by Designated Intermediate System (DIS). Regards,Rahul...
View ArticleRe: MPLS VPNs, Route-Reflection, and SPRING with IS-IS on QFX5100
Hi, ------------------------------------------------------------------------------------------------------------------------------------------------------------------We want to use a separate loopback...
View ArticleRe: Juniper MX maximum MTU
Hello,aarriola wrote: I was checking the maximum MTU I can configure in a MX960 and it was 9192, but in a EX4200 it's 9216. Why the 24 bytes difference? Usually max MTU is one of chipset...
View ArticleRe: MPLS, RSVP-TE - number of LSPs question
For the full description of load balancing a single LSP over an AE see this documentation....
View ArticleRe: Policy option import direct not working
Hi Federico, As steve mentioned, please check if the routes are showing as direct in the source table.When "term 500 reject" or "from protocol direct" is removed, you are allowing other then protocol...
View ArticleRe: MPLS VPNs, Route-Reflection, and SPRING with IS-IS on QFX5100
Thank you all for the responses. It does not appear as though JunOS supports implementation of SPRING supports this, presently. Maybe 17.3? 17.4? 18.1? Fingers crossed. Either way, I went with...
View ArticleRe: Juniper MX maximum MTU
Hello Alex. Thank you very much for taking the time to reply. I understand EX and MX have different chipsets and thus can have a different MTU. I believe my question could be: why would Juniper decide...
View Article