Hi,
I`m trying to close a l2circuit between an MX104 and Cisco ASR903 using l2vpn on cisco...
What i trying to do is set IRB into a l2circuit that i can see o ASR903 but the l2circuit dont get UP.
neighbor 10.22.0.13 {
interface irb.99 {
virtual-circuit-id 99;
no-control-word;
encapsulation-type ethernet-vlan;
ignore-mtu-mismatch;
}
}
show interfaces irb
unit 99 {
family inet {
address 186.193.240.1/24;
}
}
I getting the NP status on MX :
show l2circuit connections
Layer-2 Circuit Connections:
Legend for connection status (St)
EI -- encapsulation invalid NP -- interface h/w not present
MM -- mtu mismatch Dn -- down
EM -- encapsulation mismatch VC-Dn -- Virtual circuit Down
CM -- control-word mismatch Up -- operational
VM -- vlan id mismatch CF -- Call admission control failure
OL -- no outgoing label IB -- TDM incompatible bitrate
NC -- intf encaps not CCC/TCC TM -- TDM misconfiguration
BK -- Backup Connection ST -- Standby Connection
CB -- rcvd cell-bundle size bad SP -- Static Pseudowire
LD -- local site signaled down RS -- remote site standby
RD -- remote site signaled down HS -- Hot-standby Connection
XX -- unknown
Legend for interface status
Up -- operational
Dn -- down
Neighbor: 10.22.0.13
Interface Type St Time last up # Up trans
irb.99(vc 99) rmt NP