Hi Steve,
I might have phrased the question wrongly. what am looking for is not bundling 7 seperate STM1s on different ports but crossconnecting 7 STM1s on STM16 port. my router has STM16 port and this port is conected to ADM box on STM16 port too.
i have attached network diagram to clarify.
now i have purchased 7 STM1s and am required to terminate those 7 STM1s on the STM16 port (am not sure if this even possible). personaly i was thinking, the stm16 port expects the whole STM16 frame/payload to be complete, meaning it can accept 16 X STM1s and not anything less or more. is this the case? the 7 STM1s are are delivered/crossconnected on the same STM16 pipe from end to end via the SDH boxes but the challenge now is how to terminate those 7 STM1s on STM16 port on the MX. is there a way to tell the router how many STM1s it should expect or its by deafault full port capacity? like STM16 port expects 16 STM1s and STM4 port expects 4 STM1s ..
Regards,
Lish.