Re: Framed-IPv6-Prefix incorrect
Hi Rahul, I have completed a separate test and the results are as follows: Framed-IPv6-Prefix - xxxx:xxxx:006d:224b::/64What is assigned by the RADIUS is:Sent Access-Accept Id 10 from 195.80.0.38:1812...
View ArticleRe: Framed-IPv6-Prefix incorrect
From radius, we're getting NDRA prefix and from cli PD is assigned. CPE gets the /64 and connvert it to /128 using EUI-64. Regards,Rahul
View ArticleRe: Framed-IPv6-Prefix incorrect
Hi Rahul, I found the issue by querying the sql database from the command line with the following command: select * from radgroupreply; And found that the user was using a different profile. Since...
View ArticleClik here to view.
MX104 vpls in logical system
Hello everyone!I`m trying to set up vpls connection between two sites in my lab environment.I got 4 logical systems set up like this: PE1 { interfaces { ge-0/1/8 { unit 700 { encapsulation vlan-vpls;...
View ArticleRe: MX104 vpls in logical system
Since your using logical-system could you try to ping from PE to PE & see how it goes?ping vpls instance <name> destination-mac <MAC> source-ip <IpAddr> logical-system...
View ArticleClik here to view.
Filter Based Forwading / Policy Based Routing on Locally Originated Traffic
Hello, I have question regarding FBF/PBR. Is it possible to apply it to locally originated traffic, that is, traffic generated on the local device, or is it only applicable to transit traffic ?...
View ArticleRe: MX104 vpls in logical system
Hello.run show vpls mac-table logical-system PE1MAC flags (S -static MAC, D -dynamic MAC, L -locally learned, C -Control MAC O -OVSDB MAC, SE -Statistics enabled, NM -Non configured MAC, R -Remote PE...
View ArticleRe: MX104 vpls in logical system
Hi, An exclamation point (!) indicates that an echo reply was received and so that means ping is fine, you basically have end to end reachability....
View ArticleRe: MX104 vpls in logical system
The problem that i still cannot ping through the vpls-tunnel.I got two CE devices with IP address assigned and still no ping.
View ArticleRe: MX104 vpls in logical system
hmm.. could you add the family vpls on the PE-CE facing interfaces. ge-x/x/x { vlan-tagging; encapsulation vlan-vpls; unit xxx { encapsulation vlan-vpls; vlan-id xxx;...
View ArticleRe: MX104 vpls in logical system
I cannot do this in logical system - only to configure unit.But in default instance i got: top show interfaces ge-0/1/8 { vlan-tagging; encapsulation vlan-vpls; } ge-0/1/9 { vlan-tagging;...
View ArticleRe: MX104 vpls in logical system
Just noticed vlans are different on PE-CE (PE1 & PE4).please configure same vlan at interface and update routing-instance with the correction. PE4: ge-0/1/9 { unit 600 {...
View Articlegre tunnel on bridge
hello, it is possible to configure a gre tunnel on a bridge domain with ms-dpc? i've configured a virtual switch but irb interface cannot be added..can you tell if it is possible? Thanks
View ArticleRe: gre tunnel on bridge
Whats the JUNOS version you're on? Junos OS Release 15.1R1 or later running on an MX Series router with...
View ArticleRe: Filter Based Forwading / Policy Based Routing on Locally Originated Traffic
Hi,I think it should be possible, but may need some lab testing. I do see that we support FBF in the output direction and documentation does not say it is restricted for host generated traffic. Can you...
View ArticleRe: Inter vrrp-group routing
Hi,I was just thinking about it, if it is same unit on which you have 3 different groups configured on one primary and 2 secondary IP addresses, then from routing perspective all the routes will be in...
View ArticleVPC/EtherChannel over Juniper VPLS
Hello all, By default, will a VPLS allow LACP BPDU packets of a Cisco EtherChannel to be flooded on a VPLS instance? If not, is there a trick similar to "forward-lacp" option on Brocade router? I have...
View ArticleLooking for Policer's root oid for physical ports.
Hello everyone!I don't know in which part of forum i must post this topic. Try to post here. So, can you help me with finding oid of policer for physical ports(we have MX960). Thank you!
View Article